Hi, I want to take attention to our new product.
It is new Full Stand Alone Neuron Torch Height Control (THC) works with any CNC (Mach3, Mach4, Linux EMC2 and other). Controller use discrete I/O interface to CNC and plasma cutter.
More information on our web site
http://neuroncnc.com/products/neuronaloneUserManual
http://neuroncnc.com/assets/docs/NeuronSimplicityUserManual.pdfThe Neuron.THC Simplicity consists of the following components:
-Control module
-Plasma supply interface PCB (Voltage Divider)
-CNC interface PCB
The Neuron.THC Simplicity comes with the following features:
-Single chip microprocessor based compact control, easy to install almost anywhere
-Digital display and set arc voltage and other parameters, easy to learn and operate
-Works with ALL plasma cutters
-Controls Z axis motor driver directly (Pulse/Dir interace, internal motion controller, software PID control loop)
-30 cut profiles for different metal thicknesses. Quickly switch between profiles and the ability to quick edit them
-Set point voltage range 25 - 250V
-Set Point voltage resolution 0.5V
-Maximum control accuracy +/- 0.25V
-Height control accuracy +/-0.125 mm (.005") using a properly configured Z-axis.
-Works in Inches or Millimeters mode
-Automatic or manual control of the cutting sequence
-Sample voltage mode - THC measures the voltage at the end of the AVC Delay and uses it as a set point for the remainder of the cut
-Automatic Collision Avoidance. This safety feature allows the control to automatically adjust the torch height during a cut to help prevent torch crashes
-THC OFF hardware input for control from CNC to disable automatic control when corners, end of cut, circle of small radius
-Programmable arc voltage limiter Lock Head Down to help prevent torch diving and crashing when crossing a kerf, corners, end of cut
-Programmable arc voltage control loop dynamic (gain) value
-Works with Float Head and Ohmic sensors for IHS simultaneously (availability of ohmic input depend from controller version PCB)
-Shot mode – can use for marking centers of the holes
-Improved Jog - the lifter initially jogs 0.25 mm. After 0.5 second, it begins continuous motion at the IHS Speed. After 1.5 seconds, the lifter increases the speed to the programmed Manual Speed
-Programmable torch retract delay. This future for example can use for disabling plasma power supply before end of cut (few tens of milliseconds) without motion stop for reducing pierce divots
-Built in Testing mode of the cutting sequence
-Integrated diagnostic system informs the operator about errors that occurred
-All I/O interface (include arc voltage) are isolated and simple wiring (Cat5e cables and RJ45 connectors)
Signals from/to plasma source to control module interface:
-Arc voltage: 0-12.5V (20:1 input) or 0-350 V Raw arc voltage input
-Start plasma (Normal Open Relay Contact 100 mA protected) output
-ArcOK (Transfer) input
Signals from/to CNC to control module:
-Cycle Start (5V DC for activation, polarity is not important) input
-THC OFF (5V DC for activation, polarity is not important) input
-Motion (Normal Open relay contacts 100 mA protected) output
Guest
Show Posts
