Hello Guest it is March 28, 2024, 04:38:51 PM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - chvet73

Pages: 1
1
General Mach Discussion / Re: max 10cl on Mach3
« on: February 23, 2007, 12:10:48 PM »
Help this lame guy and direct me to where it is.  Because I'm not seeing it. Thanks

2
General Mach Discussion / Re: max 10cl on Mach3
« on: February 23, 2007, 12:10:26 PM »
Help this lame guy and direct me to where it is.  Because I'm not seeing it. Thanks

3
General Mach Discussion / max 10cl on Mach3
« on: February 20, 2007, 12:53:33 PM »
Anyone have a xml file for this setup?
Thanks

4
General Mach Discussion / Re: mach2 with max10 cl
« on: February 17, 2007, 01:11:55 AM »
I ordered the Mach3 but in my school it will be a month at least until the wheels around here get it to me.  Schools move slow.  As soon as I get it I'll post our progress.

5
General Mach Discussion / mach2 with max10 cl
« on: February 15, 2007, 01:43:14 PM »
Hi,
We are a school who purchased a Maxnc 10cl in March 05. We run only
XP on our network. I had made the machine operate in dos mode with
it's own software on an old computer which we no longer have.
When I spoke to Maxnc who at that time advertised that the machine
would run under XP. I have to say their attitude leaves something
to be desired. They seem to care less. After my conversations with
them I noticed that they changed their website to reflect that the
product did not run under XP.
So, after some time we learned that the machine would possibly run
with Mach2 software. We have downloaded the software and are in the
process of upgrading to Mach3. But schools move slow, so I want to
get this mmachine running with at least Mach2.
Once the software was installed when we attempted to configure it we
have failed to get the results we are looking for. So at that pooint
I changed the xml file to the Maxnc final that is available on this
site.
In either case my motor runs wild. as soon as the machine is turned
on the motor is on and going full speed. On the diagnostic page the
stop led is flashing. Nothing effects the motor. The reset button
flases and nothing happens when you reset it.
So at this point, where do I go from here.
Thanks

Pages: 1