Hello Guest it is April 16, 2024, 02:10:21 PM
Profile Guest

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - R

Pages: 1
1
General Mach Discussion / Re: Question regarding dsp ,control boards
« on: March 06, 2011, 04:38:41 PM »
Thanks  tweaky,

I,m now looking at purchasing this laser hobby system by full spectrum engineering. They use a mach3 compatible board wondering if you have any insight with their products?

2
General Mach Discussion / Question regarding dsp ,control boards
« on: February 27, 2011, 06:12:39 AM »
Hello, I'm trying to understand the difference between dsp based control systems and mach 3 based motion  control boards. ( this being for laser engravers marketed online).  Most of the Chinese laser engravers provide dsp control but this does not say a lot, and i,m not sure if it is compatable to the mach3 software. I,m familiar with the Mach 3 software but need an explanation regarding Mach based control hardware and other 'dsp,' control boards.

Please advise,

Regards.

Pages: 1