Hello Guest it is March 28, 2024, 05:04:20 PM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - dpaish

Pages: 1
1
Mach Screens / Looking To Hire to Build Custom Screen
« on: July 06, 2023, 05:12:30 PM »
Greetings,
I am building a custom cut to length line.  Basically, an expensive tape measure to a chop saw.  I need a custom Mach 3 screen developed.  It only has one axis but need custom screen for movement.

Regards,
Dennis Paish 

2
General Mach Discussion / Re: What Happened To My Code?
« on: February 22, 2011, 12:17:01 AM »
I will see if I can find the code.  It maybe at work.  In Visual Mill I run the simulation and the purple swirls are not there.  It only occurs when I open the post in Mach3, if that helps.

I thought I would add this information.

Dennis

3
General Mach Discussion / What Happened To My Code?
« on: February 22, 2011, 12:04:27 AM »
Greetings,
I've been using the same Mach 3 version (Only 6 months old) and my computer is dedicated to my CNC Mill (no internet nothing),  The past couple days my posts (not all of them but usually half) have been corrupted or something.  I do all my drawings on Coral Draw X4, then I use the Leonard Software to export the DXF, then into Visual Mill then I post it to Mach 3.  This is crazy and driving me almost the same tiring to figure this out.  Any idea or suggestions would be great.  I have added a picture to this post.  Look at the purple circles on the display.  WHY?

Regards,

Dennis

Pages: 1