Messages

1

General Mach Discussion / Re: Mach 3 servo

« on: February 23, 2011, 09:40:03 AM »

5V Power Supply for Breakout Board , 110V input
Variable AC Output Transformer MAX.20A TDGC - 2KM:
1 PCS Geckodrive Servo Motor Drive G320:
C10
KL34-180-90 (NEMA 34) Dual Shaft
US Digital: E5S-500-250-EG-PKG2
CA-3131 connecting cable
KL- 7220 72V/20A

This is the setup that i have. All the ports and pins are set. any help would be great thank you.
 

2

General Mach Discussion / Mach 3 servo

« on: February 20, 2011, 11:11:50 PM »

can someone please help!!! Just received 2 Gecko drives G320X DC servo drive from Kelinginc all is wired up and ready to run but for some reason the codes aren't going to the motors to turn. can someone please configure the setup. Thank you in advance.