1
General Mach Discussion / Re: Home switch stopped working...
« on: February 16, 2011, 10:59:02 AM »Ok, just noticed you have A axis set as angular in General Config, not sure if it would make a difference. Also not sure about the Home Slave with Master setting, you have it unchecked. I have never had a slaved axis other than the dual spindles on the coil winder so not sure which way these should be.
Hood
Bingo! Thanks Hood! It wasn't the A is angular, I had already tried that. I don't know how it got unchecked (or if it was ever checked) but setting the Home Slave with Master setting fixed it.