Hello Guest it is May 16, 2021, 01:58:20 AM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - tthomp1334

Pages: 1 2 »
1
Mach3 and G-Rex / Mach 3 loads but will not run
« on: January 09, 2020, 05:39:10 PM »
I had a computer crash and can not get the software to work on the new computer. 32 bitt

It will load but will not work, it will load a file but that is all, reset button or zero axis also do not work.

I am lost as to what to do, have orders and can not cut them

2
General Mach Discussion / Re: Software will load but nothing works
« on: January 09, 2020, 05:35:16 PM »
This is mach 3 software

3
General Mach Discussion / Software will load but nothing works
« on: January 09, 2020, 05:06:09 PM »
I had a computer crash and can not get the software to work on the new computer. 32 bitt

It will load but will not work, it will load a file but that is all, reset button or zero axis also do not work.

I am lost as to what to do, have orders and can not cut them

4
General Mach Discussion / Re: Running Mach3 version 2 in windows 7
« on: February 25, 2019, 08:52:05 PM »
Will mach4 run on 64 bit

Milton

5
General Mach Discussion / Re: Running Mach3 version 2 in windows 7
« on: February 25, 2019, 08:44:16 PM »
Thanks

Milton

6
General Mach Discussion / Re: Running Mach3 version 2 in windows 7
« on: February 25, 2019, 08:31:07 PM »
When I run driver test this is what I get

No Driver sensed installed

Milton

7
General Mach Discussion / Re: Running Mach3 version 2 in windows 7
« on: February 25, 2019, 08:13:07 PM »
Tried that and did not work. ???
64 bit

Milton

8
General Mach Discussion / Running Mach3 version 2 in windows 7
« on: February 25, 2019, 07:41:49 PM »
I was running the program under windows 95 with no problems and computer crashed, New computer is running windows 7

When loading the software I do not get a prompt to load the port driver and system is not working.

Thanh's
  Milton

9
General Mach Discussion / Re: Another newbie problem.
« on: February 14, 2011, 07:34:58 PM »
I don’t even know what a xml is, just shows you how computer savvy I am.

Been trying to get this to work for two day’s, just about ready to stick Turbo cnc back on it. LOL

10
General Mach Discussion / Re: Another newbie problem.
« on: February 14, 2011, 06:43:59 PM »
You just totally lost me. LOL


Milton

Pages: 1 2 »