Messages

1

LazyTurn / Re: Tool Issue

« on: March 28, 2012, 09:38:51 AM »

Thanks Rich,

I will give this a try.

Bob

2

LazyTurn / Tool Issue

« on: March 23, 2012, 10:29:07 AM »

I am new to Lazy Turn.   I have printed the manual, read the manual and played with the software.   I built a manual lathe for cutting ice.   I currently use a 1/2 Ball nose end mill with a 5inch cutting edge.   I cut up to 2 1/2 deep in one final pass.   I am trying to do the same thing in LT.   However, I am problems figuring it out how to do it.  I would appreciate any assistance.

Thanks in advance
Bob