Messages

1

General Mach Discussion / Re: Hold Down Clamps

« on: February 19, 2011, 03:58:13 PM »

Thanks kolias - wish I done that from the get go.
I will put it on my 2 Do list.

Along with the DIY clamps.

2

General Mach Discussion / Re: Hold Down Clamps

« on: February 18, 2011, 09:00:56 PM »

So my table is setup and running now.
Wandering if any of you made your T slot tables?
After building table, software, and accessories I didn't have the $ to buy T slot's so I was going to use shelf pegs. Insert where needed in pre drilled holes.  Said holes are 1" apart with odd rows offset 1".
BUT I like the idea of being able to hold the piece down and not just from sliding around.

If so How did you make your T slot tables?

3

General Mach Discussion / Re: Problems with display mode

« on: January 28, 2011, 06:40:04 PM »

Sweet
Tx so much for the info, fix, and speedy reply.

4

General Mach Discussion / Re: Problems with display mode

« on: January 28, 2011, 05:15:49 PM »

Newbie here.
I use a track ball so I don't have a 3rd wheel to zoom. Wondered why my screen want like the video.

So where/how do you add "DoOemButton (160) at the end of the VB in the button and it now regen's automatically."
As I assume this is meaning the Regin Toolpath button?