Hello Guest it is October 21, 2021, 09:06:28 AM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.

Messages - hhbarney

Pages: 1
Third party software and hardware support forums. / Ajax or Vitalsystems?
« on: January 22, 2011, 04:02:24 PM »
I have an old bridgeport mill which has just been reconditioned. It has an old Anilam cnc controller on it with linear encoders and servos. I want to keep the servo motors, amps and feedback scales and replace the controller with Mach 3 and either the Vitalsystems ethernet controller or the Ajax boards. Any feedback on which to choose would be greatly appreciated.

Pages: 1