1
General Mach Discussion / Re: Mach3 stops and looses control
« on: January 17, 2011, 05:03:30 PM »
Hi,
I am having the same issue, I am able to repeatably have 3 different programs stop on lines 495-497, I can take the programs and remove some lines and start them again and they will run through that line until they again hit lines 495-497. Any ideas?
I am having the same issue, I am able to repeatably have 3 different programs stop on lines 495-497, I can take the programs and remove some lines and start them again and they will run through that line until they again hit lines 495-497. Any ideas?