Hello Guest it is March 29, 2024, 03:09:50 AM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - songlight

Pages: 1
1
General Mach Discussion / Re: Homing does not see home switches.CRASH!!!!
« on: October 30, 2012, 07:05:24 PM »
Sorry,  what is an xml?:

2
General Mach Discussion / Re: Homing does not see home switches.CRASH!!!!
« on: October 30, 2012, 04:19:10 PM »
My home switches are working but there is no indication in the diagnostic screen (lighted segment) in the home switches area.  There is only a lighted led indicated in the printer port configuration when the switches are pressed on the mill.

Any help would be appreciated.

3
General Mach Discussion / Re: Homing does not see home switches.CRASH!!!!
« on: October 30, 2012, 04:12:57 PM »
Home Off? Are you meaning RefAll?
If you attach your xml I will see if there is a problem in your config.
Hood

4
General Mach Discussion / Re: questions
« on: January 20, 2011, 11:04:22 PM »
Hi Rich
Will post tomorrow.
Too hard to post on phone. Thanks for reply.

5
General Mach Discussion / Re: questions
« on: January 20, 2011, 07:46:11 PM »
Can someone direct me to users of Sherline cnc mills?  I have a Sherline rotary problem and need some help.  Thanks.

Songlight

7
Hello, I am a newbie on this site, an electronic hobbiest and learning on a Sherline mill.  I am enjoying learning Mach3 but having some problems using the Sherline rotary cnc table.  While .the x,y,z axis work okay, the rotary table will on run at a certain speed and it does not run smoothly.

I have tried different configurations but still it does not work correctly and I can't run it and another axis at the same time.

Any help would be appreciated.

Pages: 1