Hello Guest it is October 20, 2019, 05:33:11 AM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - generlsocial

Pages: 1
1
General Mach Discussion / DC-03 DigiSpeed GX V3
« on: July 07, 2011, 04:01:01 PM »
Hello Everyone,

I just got at DC-03 DigiSpeed GX V3 to control my chinese C02 laser. I want to use Mach 3 or EMC2.

Has anybody gotten it running? What is the wiring diagram? Which pins do you use on the parallel port?

Here's a picture of it: http://mambohead.com/2011/07/laser-controller-design/

I will get through it eventually but if someone already has it working perhaps they could share what they did?

Thanks in advance!

Darcy

Pages: 1