Hello Guest it is March 29, 2024, 09:10:17 AM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - guyver

Pages: 1
1
General Mach Discussion / Re: mach3 backlash
« on: March 04, 2011, 04:47:57 AM »
thanks for the info i will look in to it

my backlash is .05mm on X

2
General Mach Discussion / Re: mach3 backlash
« on: March 03, 2011, 07:16:38 AM »

all my machine does is stop for a few seconds with backlash on
even with a silly amount of backlash is does not make any difference just stops for a few seconds

i will try shuttle accel / backlash speed but i`m sure i have done this before
any good stating points or is it just trial n error ??

3
General Mach Discussion / mach3 backlash
« on: March 02, 2011, 01:57:25 PM »
Hi guys been trying mach3 out for a while now
anyone using motion control products MSD542 drivers and got the backlash compensation to work ? in mach 3

Pages: 1