Hello Guest it is March 28, 2024, 04:25:07 PM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - 7654321

Pages: 1 2 »
1
SmoothStepper USB / Re: Turning on the lights trips a limit switch
« on: October 19, 2011, 04:46:04 PM »
did you replace the ss usb cable?

2
SmoothStepper USB / Re: Turning on the lights trips a limit switch
« on: October 19, 2011, 04:36:42 PM »
I have same problem on z axes... limit switch trips as soon as i jog.

3
General Mach Discussion / Re: how to config z axis HCNC
« on: February 19, 2011, 06:24:19 AM »
its a router and the z movement is small. 1 inch is a full move so to move z ha;f way I need to enter z-.5. Is this the way its done?
Thanks
Al

4
General Mach Discussion / Re: how to config z axis HCNC
« on: February 18, 2011, 05:49:22 PM »
hcnc is Hobbycnc

5
General Mach Discussion / Re: how to config z axis HCNC
« on: February 18, 2011, 04:11:37 PM »
HI hood. I m using the program in Mach3 instructions where each axes is run 50 times
but when I get to z axis I need to enter fractions of a n inch to run within the throw of the
z on the hcnc machine.

6
General Mach Discussion / how to config z axis HCNC
« on: February 18, 2011, 04:03:47 PM »
how to config z axis HCNC? do I need to program all  fractions or is there a way to set it up properly?
Thanks

7
General Mach Discussion / axes cant decide direction
« on: February 04, 2011, 03:06:55 PM »
axes cant decide direction
when I send all to home somtimes an axis goes in the wrong direction...

8
General Mach Discussion / Re: motor tuning
« on: January 30, 2011, 07:51:19 AM »
thanks all ok

9
General Mach Discussion / Re: motor tuning
« on: January 23, 2011, 02:54:13 PM »
Help I have same problem no motor tuning menu on new laptop but plugged the usb back into
the old laptop and motor tuning showed up but mors wont run on old laptop....crazy

10
General Mach Discussion / Re: Wiring Limit & Home Switch
« on: January 21, 2011, 10:06:59 AM »
all in series 2 inputs pin11 and Ground and the shield grounded at AC Green

Pages: 1 2 »