1
General Mach Discussion / Re: problem size in mach3
« on: March 22, 2011, 12:06:18 AM »
Hood,
Thank you very much.. it works well.
Thank you very much.. it works well.
This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.
Mr. Hood, I upgraded my z axis from 6" to 12" processing distance. Now I have lead screw
KERK Brand Anti-Backlash Nuts on all axis
-0.1 pitch lead screws. Standard (Feed rate of 150 inch per minute)
-Kerk(TM) Nut
+ Resolution .0005"
+ No load backlash .0005"
+ Double End Support.
Nema23 Stepper motor 1/8 microstep.
Can you help me with the right motor setting with this one.
Thanks for your help....