Hello Guest it is March 29, 2024, 05:28:09 AM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - RPM1956

Pages: 1
1
Brains Development / Share your Brains?
« on: May 24, 2012, 01:48:40 PM »
I have a Bridgeport Series 2 Mill running with Ajax control and Mach 3. I need Brains for spindle fault and low lube. Spindle fault being X,Y,Z programed moves stop if spindle overload kicks out. Low lube being spindle wont run if lubricator is empty.

2
General Mach Discussion / Re: Spindle Fault and Low Lube not Working
« on: December 18, 2010, 06:20:21 PM »
Found I/O map page 10 maybe this will help. Thanks to all for the input.

rpm1956

3
General Mach Discussion / Re: Spindle Fault and Low Lube not Working
« on: December 17, 2010, 09:34:04 AM »
No idea! I've looked through manual and found nothing on that.

RPM

4
General Mach Discussion / Re: Spindle Fault and Low Lube not Working
« on: December 17, 2010, 07:14:46 AM »
Been there done that for 2 weeks no answer!

5
General Mach Discussion / Spindle Fault and Low Lube not Working
« on: December 16, 2010, 07:39:38 PM »
Hello

I have a Bridgeport Series 2 mill running with AJAX control MPU11, DC3IOB board and MACH 3 software. Just found out Spindle Fault and Low Lube are not working. Spindle overload kicked out and spindle stopped but feed kept running. Low Lube does nothing. Looks like both are wired per diagram. Is this a config issue or do I need a brain to turn these on? Need some HELP!

RPM1956


Pages: 1