Hello Guest it is March 29, 2024, 12:01:10 PM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - HG810

Pages: 1
1
NC Pod / Mach pins required for homing operation
« on: December 26, 2010, 10:59:33 AM »
Hello,

I try to control spindle by output B if i succeed i will let you know.
but for home inputs which mach pins i use for below,

X Home:Port#1 Pin#__?
Y Home:Port#1 Pin#__?
Z Home:Port#1 Pin#__?

Thanks,
Hash

 

2
Dear freddy,

I use dc motor to drive my spindle. And i want to control (on/off) with job starting and ending so Is it possible to use output B of ncpod with TTL logic for my spindle drive circuitry?

I found by ncpodusermanual.pdf that I have to use mach pin 3 for output B of ncpod.

Also i found that all homing inputs "handled by ncpod" So my question is how can mach3 let know that any home switch actuate or not? although we are not configure any home input in ports and pins section.

Thanking you,
Hash

3
Dear Freddy,

Hope now you have your machine.
I need mach3 pin details mapped according to ncpod pins.
Machine overview,
> 3-axis (engraving for 2.5D) step pin & dir pin required for Motor Outputs
> x-y-z Homing Pins & E-Stop for Input Signals
> Spindle O/P I use O/P B in ncpod

regards,
Hash

4
NC Pod / Welcome To The NC Pod Development, Discussion and Support Topic
« on: December 16, 2010, 02:20:36 PM »
Can anyone give me mach pin details for ncpod?
I'm using DeskPod-NcPod-PlugIn-3.00
I need details of,
> Motor Outputs
> Input Signals
> Output Signals

thanks,
Hash

Pages: 1