Guest
Show Posts
1
General Mach Discussion / Re: Using Isel CNC Controller C 142-4 with Mach3 ??
« on: August 19, 2017, 01:53:46 PM »
Hi Behnk
I'm just doing this. I've sucsessfully moved the motors with the Pulse step pins on the back of the drivers (just soldered wires on the back of the AZ8061/1 board.
I am using a cheap chineese 5ax Mach3 board ant it runs fine.
I just need to route the limit switches now. It's a simple setup.
https://www.isel.com/en/downloads/dl/file/id/4261/c142_4_1_hardware_manual_complete.pdf
Page 26 hase the driver pins. Just draw wires from the Clock (CLK),Direction and Motor GND to your BOB.
Good Luck
I'm just doing this. I've sucsessfully moved the motors with the Pulse step pins on the back of the drivers (just soldered wires on the back of the AZ8061/1 board.
I am using a cheap chineese 5ax Mach3 board ant it runs fine.
I just need to route the limit switches now. It's a simple setup.
https://www.isel.com/en/downloads/dl/file/id/4261/c142_4_1_hardware_manual_complete.pdf
Page 26 hase the driver pins. Just draw wires from the Clock (CLK),Direction and Motor GND to your BOB.
Good Luck