Messages

1

General Mach Discussion / Re: Serial Port control under cypress enable

« on: January 04, 2011, 05:23:29 PM »

I noted that M3 and M4 was included and now I also made the M5. The last "End If" in the speed I removed.
now after starting the duet and run the M2000 in the MDI mode the led's flash and the green one is on. if i run M3 S500 in the MDI mode I also hear the relay click on. The message in the Status  line is (Scripter Compile Error. In: SpindleSpeed.mis) and the spindle does not turn. When I run after that M4 S500 or M5 the relay does not click anymore. (Message in the Status line: Spindle Already CW)
When I run the speed Script in the VB Script Editor I get (Error on line:3-Sub or function not defined:RPM)
Is It possible that in the Speed script is still something missing? I also believe the M5 Scrip does not realy stop the Spindle because I should hear the relay again, right?
I think one problem is the M5 script because after M5 I should be able again to hear the relay click again with M3 or M4. And the other is the speed script.

2

General Mach Discussion / Re: Serial Port control under cypress enable

« on: January 03, 2011, 04:07:04 PM »

Hello again, Thank you for the script! I tried it out and I was able to send the duet.dat to the boxford. The led's flash and then stop. That is already a great success to me, tnx.  But I still have a problem with the speed!
I saved your script under spindlespeed as a macro. If I want to run the spindle i get an error in the spindlespeed. If I run it in the VB Script editor I get (compile error: Syntax error) in the last line by End[/b] If.
Do you have any idea what i do wrong?

3

General Mach Discussion / Re: Serial Port control under cypress enable

« on: December 16, 2010, 03:42:02 PM »

Hi “The_black_cat_dies” or anyone.
I just got an boxford duet and I want to control it with mach3. And I have the same problem, i can’t let my Spindel run! Unfortunately i don’t have any experience with VB or Mach3. I just startet up experimenting with the duet. I was reading the posts here and have seen you were able to solve the problem. Maybe you can help me to let the spindel of my duet run. I would be glad to get the code for the serial! And maybe also some tips how to configurate Mach.
Any help would be great...