1
General Mach Discussion / Re: RhinoCAM post processor
« on: October 14, 2006, 06:56:59 AM »
Hi kdoney,
when i changed from Mach2 to Mach3 i had the same error.
If you edit the g-code with Mach it will work fine again. Only delete the 0 behind G43, that`s all.
I think you can change the Postprocessor settings inside Rhinocam so it will never write the 0 again.
Andy
when i changed from Mach2 to Mach3 i had the same error.
If you edit the g-code with Mach it will work fine again. Only delete the 0 behind G43, that`s all.
I think you can change the Postprocessor settings inside Rhinocam so it will never write the 0 again.
Andy