Hello Guest it is April 09, 2020, 05:50:18 PM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - gifre70

Pages: 1 2
1
Works in progress / Re: All in one lathe screen (Beta)
« on: January 04, 2011, 06:09:09 PM »
I am using your very nice screen softselect an i would comment over the feed rate override %, he is working sure 100*100 you only need
in general config decrease the "lookahead" number. to see the effect.

Tks. softselect for your work.

Josep

2
Spanish / Re: Error de torno
« on: November 16, 2008, 01:42:26 PM »
hola..
en config, general config, desactiva la casilla "Use watchdogs"
Saludos Josep

3
PoKeys / Re: pokeys analog
« on: November 13, 2008, 06:10:29 PM »
Hi Hood perhaps this Brain help you

4
PoKeys / Re: Need Help with Pokey & Mach
« on: October 21, 2008, 07:18:34 PM »
try run mach3 when pokeys setup program still runs in background.

Josep

5
PoKeys / Re: pokeys analog
« on: October 21, 2008, 07:08:41 AM »
can you explain a litle more??

josep

6
PoKeys / pokeys analog
« on: October 20, 2008, 06:29:26 PM »
any one know how use analog inputs in mach3 for speed override, spindle override, ?
i tried use brain  it recognizes the analog input but i dont know how terminate the rug for implement the two overrides.

Josep.

7
PoKeys / Re: PoKeys Plug-in
« on: September 11, 2008, 03:01:52 PM »
Ok Hood many tks for your help.  I received my pokeys board two days ago and i am unable to setup it.
Sure i have Device ID set to 0 i think is the default.
Josep

8
PoKeys / Re: PoKeys Plug-in
« on: September 11, 2008, 07:47:24 AM »
No don`t work..
Hood are you running the last version? if negative can you send me the version you are running?
i can see how the pin status change in pokeys software but never in Mach3 i think is possible software failure because under pokeys software control all is OK.
Josep.

9
PoKeys / Re: PoKeys Plug-in
« on: September 10, 2008, 06:10:39 PM »
OK i installed the pokeys software V1.8 and i can configure any pin i like. then send the config pins to the board. Of course i manage it but if configure a pin as input and click the key mapping window asigning a keyboard key to this input pin then mach3 recognizes it when i short this input to ground.
i reseted the board "pin 54 to ground and connect the usb cable" reconfigured a only one pin input and don`t work.
Josep

10
PoKeys / Re: PoKeys Plug-in
« on: September 10, 2008, 05:05:15 PM »
I have a problem !!!
I tried the two ways you explain me but my board only run in keyboard emulation. port #10 pin 1 don`t work in any way
I use the plugin downloaded from pokeys page and  Mach3 V3.041.     Hood do you see activity in Pokeys data diagnostics mach3 window??

Pages: 1 2