Hello Guest it is July 27, 2021, 10:59:32 AM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.

Messages - nqwog

Pages: 1
General Mach Discussion / Re: CNC MISSING THE ODD STEP
« on: August 05, 2011, 05:17:01 PM »
Thanks to all for your advice.
I will try all your items and see what happens.

General Mach Discussion / CNC MISSING THE ODD STEP
« on: August 04, 2011, 08:32:47 PM »
Hi Can anyone give me some advise on my Machine missing steps.
I have a TB6560 driver board. When machening I loose the odd step after a few minutes of working.
I disconnected the screw from the stepper and it did the same. I change to 36000mhz but still no difference.
I reduced the velocity and acceleration , it is slightly better but still looses a step every now and then.
It appears to be getting worse. My gut feel is the TB6560 is the problem(chinese driver so I guess I goy what I paid for.)
Am I on the right track?

Thanks Gerry
I will give it a try

 I am looking for the G code for a Fleur De leise (not sure of spelling) around 100mm to 200mm high to cut on my mill
Thanks Jim

General Mach Discussion / Re: Reversing steppers in Mach3
« on: December 28, 2010, 04:24:27 PM »
Thanks Gerry
That saved a lot of time .
I am new to CNC routing and have just finished my first machine. It works fine now all I have to do is learn how to get the best out of it.
Thanks again

General Mach Discussion / Reversing steppers in Mach3
« on: December 25, 2010, 08:35:19 PM »
Hi can anyone help me reverse the direction of motors without changing wiring. I did this once but can not rember how I did it old age is creeping in.
Thanks Jim

General Mach Discussion / Re: Setting up safe limit switches
« on: December 12, 2010, 10:03:42 PM »
Thanks Bill
Now it all makes sense.
Regards Jim

General Mach Discussion / Re: Setting up safe limit switches
« on: December 10, 2010, 04:51:59 PM »
Thanks Jeff and Steve
Still clear as mud.
When I look at the wiring diagrame if shows GND as common and the NC OR NO as the switch. So I assume the controller terminal goes low and activates the axis stop.
I will check it out in greator depth at a later date, I am only runing very slow at the moment and doing test cuts to see what accuracy I am getting.

General Mach Discussion / Setting up safe limit switches
« on: December 09, 2010, 09:45:49 PM »
Hi all  I am a new user to Mach3 and have built a homemade 3 axis CNC router. I would like to set up limit switches in case somthing goes wrong.
My question! micro switches have a common and a NO and NC terminal. I am using a TB6560 driver .
Where do I place the wires to me if I have the 5v wire as common where does the ground wire connect as I do not want a dead short between the two.?
Keep it as simple in plain language please.
Jim ???

Pages: 1