Hello Guest it is March 29, 2024, 02:25:03 AM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - rwind

Pages: 1
1
FAQs / HELP WITH CONTROLLER SELECTION
« on: October 12, 2011, 11:51:20 PM »
i HAVE A 2003 SHOPBOT PRT 4X8 TABLE AND CONTROLLER HAS GONE POT. THE MOTORS ARE STILL GOOD. THEY HAVE THIS INFO ON THEM. VEXTRA A6497-9412KTG 2 PHASE .5 DEGREE PER STEP AND ARE 4 WIRE @4.39OHMS
AS FAR AS I KNOW I AM LOOKING FOR BREAKOUT BOARD, DRIVERS FOR 4 MOTORS , 2 ARE ON THE X,   POWER SUPPLY,  ETC.
CAN ANYONE RECCOMEND WHAT I SHOULD GET. SHOPBOT IS EXPENSIVE ON PARTS
THANK YOU

2
I did all that and the more i think about it i have been testing it on a demo version. i think i will put it on the registered version and give it a go. thank you doc

3
I followed the directions as close as i could. am using mach 3, but when i press button 5 and or 6 the z axis responds. what am i doing wrong??
I thank you in advance ???

Pages: 1