Messages

1

Mach4 General Discussion / Re: New people welcome !! Come in here and introduce your self!

« on: March 11, 2015, 11:23:13 PM »

Hi all. Just got a Mach3 license and loaded the software. No hardware hooked up. Got the screen to come up but can't get the jog to work. Something simple I missed?

2

Mach4 General Discussion / Re: New people welcome !! Come in here and introduce your self!

« on: May 05, 2011, 08:29:29 PM »

Hello,

I am semi-retired which just means I still need the money but I don't want to work hard for it.

I have a couple of lasers I use for marking and welding. I was driving the welder with an old MaxNC controller/driver running in DOS. That computer finally gave up the ghost and I am looking to driving the same controller with Mach3.

I loaded the software and it seems to check out but I get no indication of position change on the axis read outs when I run a test program. I can see it stepping through the G-code lines.

This is probably something simple but not obvious to me. Any help would be appreciated.

Tony

3

General Mach Discussion / Re MAXnc

« on: November 04, 2010, 03:33:20 AM »

A quick question. Can I drive my existing MAXNC DLX controller with MACH3 software?

Thanks to anyone who can answer this.