Messages

1

General Mach Discussion / Re: Scaling problem need help

« on: October 25, 2010, 09:27:44 PM »

Thank you Al. right now the Step box says 4000 in the steps and then in the velocity its is 49.998 and the next box step pulse is 0 and the Dir pulse is 0

if I start lowering the number lets say 2000 in the box this will start lowering. Like I mentioned in the older post that I measured 1" on x and the DRO said 8.12. will I have to alter any of the other boxes ?

Am I on the right track here altering that number in the step box ?

thanks for your help
best
Romano

2

General Mach Discussion / Re: Scaling problem need help

« on: October 25, 2010, 06:17:19 PM »

hello Alenz thank you for the info. Where would i go in mach III to set up these motors ? in the setting tab ? Any info how to put the info into the correct slot would be great. I just dont want to mess anything up.
Thanks for your help
best
Romano

3

General Mach Discussion / Re: Scaling problem need help

« on: October 25, 2010, 02:35:50 PM »

Hello Hood, I am a real beginer at this. Can you tell me how to take care of this  with the steps
best
romano

4

General Mach Discussion / Scaling problem need help

« on: October 25, 2010, 01:14:15 PM »

Hello Everyone, I am new here and need some help, I have the mach 3 (maxNC) and I have a problem with the size. I load a regular g code that works fine on an accurite mill pwer and it worked fine on my friends max nc with mach 3 and comes out to size. Here is the problem when I use it on my machine (max NC OL10) that the engaving comes out 8 times smaller. The program has been installesd and reinstalled and no change. I am a new user to this and I dont want to go and change other field s etc. I have measured with a ruler 1" movement on xyz and they come in at over 8.134 on the dro. I hope someone ccan help me here I would really appreciate it.

Thank you

best
Romano