Hello Guest it is March 28, 2024, 07:43:07 PM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - jakemestre

Pages: 1
1
SmoothStepper USB / Tormach PCNC1100 ATC and SmoothStepper
« on: August 29, 2012, 12:03:51 AM »
Good Afternoon,
I tried to get a little guidance from the Tormach forum on CNCzone, but to little avail.  I've been trying to integrate the USB smoothstepper into the Tormach PCNC1100 with Auto Tool Changer.  The Tormach version of Mach3 won't allow the smoothstepper plugin to initialize and only the ATC plugin works.  Vise versa the standard Mach3 will allow smoothstepper plugin to run but no ATC.  Anybody have any ideas?  
Tormach's version of Mach3 saves all the root files into a folder C:/PCNC  where Mach just says everything in the C:/MACH.  I pulled all of the PCNC info for the ATC, macros, etc. into MACH and cloned the pins and configuration from PCNC.  Still no dice getting the ATC plugin to work though.  Any help would be much appreciated.
Jake Mestre

Pages: 1