1
Third party software and hardware support forums. / Re: cncdrive.com UC-100 and UC-300 any views, review?
« on: October 18, 2013, 04:48:31 PM »
I've just finished installing UC100's on two machines and am very happy. The installation was very straightforward, just following the instructions in the manual. They have also let me convert to running Mach on laptops with USB which makes space management in the workshop easier.
Best of all is the performance improvement. I cut some tests this afternoon and was able to run at more than twice the normal feedrate with absolutely no loss of definition from "smoothing". Basically a no fuss upgrade for very little money.
Best of all is the performance improvement. I cut some tests this afternoon and was able to run at more than twice the normal feedrate with absolutely no loss of definition from "smoothing". Basically a no fuss upgrade for very little money.