1
General Mach Discussion / Problem with smoothstepper in a new installation
« on: October 21, 2010, 09:49:26 AM »
Hi all,
I installed mach3 on cleaned PC with windows XP and few drivers installed only. Then I started to work, in few minutes the Mach froze. Through Ctrl+Alt+Del I exited Mach and tried again few times with the same problem. I restarted PC and machine and reinstalled the Mach.
Now Mach is not freezing but sometimes (may be every 5-15 minutes of work) machine stops working and error message on the picture appears. After restart of machine connection and Mach, all is ok for about 5-15 minutes of work, then it fails again.
On other PC I didn't have the same problem, it was just freezing sometimes for few seconds and worked again but i think, that it was happening because of a low performance of PC and applications running in background. The setup of Mach was absolutely same like the one I'm using now.
I'm quite helpless and I will welcome each idea.
Thank You
I installed mach3 on cleaned PC with windows XP and few drivers installed only. Then I started to work, in few minutes the Mach froze. Through Ctrl+Alt+Del I exited Mach and tried again few times with the same problem. I restarted PC and machine and reinstalled the Mach.
Now Mach is not freezing but sometimes (may be every 5-15 minutes of work) machine stops working and error message on the picture appears. After restart of machine connection and Mach, all is ok for about 5-15 minutes of work, then it fails again.
On other PC I didn't have the same problem, it was just freezing sometimes for few seconds and worked again but i think, that it was happening because of a low performance of PC and applications running in background. The setup of Mach was absolutely same like the one I'm using now.
I'm quite helpless and I will welcome each idea.
Thank You