It should work, where are you getting the input range numbers from? Device manager?
im getting the input range numbers from the device manager, yes. ill post a screenshot of the screen tomorrow.
also, I found when installing a parallel port that it auto assigned it to Lpt3. after assigning it to Lpt2( in device manager)and checking the resources in there, all was well. There were drivers to install too.
..You should see more in the "range" under the resources tab.... rather than a single location.
...Though, maybe I haven't had enough experience with different cards....I did have one older model that looked liked a card embedded with a dozen mini "kit-kat" bars that came with my scanner. It didn't work on my newer PC.
i tried setting it as LPT3 and LPT2, but the ranges stayed the same. thats just what im getting, is a range.