Thanks for the reply. I have been running Mach3 for about 7 years W/ Screenset2010 on my diy CNC without many problems. Now for some unknown reason, while running a gcode file, about every two minutes I keep getting an error code (error 3336) pop-up that shuts the program down. ArtSoft technicians dosen't know what to do about it. So I'm trying to install Mach4 V2 to see if it will correct these problem. Screenset 2010 has an M6 manual tool change that I would like to use with Mach4, but Mach4 will not run the 2010 screensets. I was wondering if it would be possible to get your latest M6 code and help getting it into my Mach4?
Thanks in advance for your help. If it wasn't for these forums I would never have my DIY CNC working as well as it does.
Gene
P.S. I don't have Mach4 completely installed yet, trying to get all of the settings just right is a pain you know where