Messages

1

General Mach Discussion / Re: problems with larger bit and machine stuttering

« on: October 10, 2010, 01:55:03 PM »

We did lower the amount of amps i believe to each of the motors, so that it would run cool and be able to run longer.  This is because we had problems with it running for a long period of time and the motors would get extremely hot.  I am carving out sculptures of mine, well the parts of a large one, lets put it that way.  We use visual mill as the translating program from cinema 4D. Visual mill posts the tap files for us to use.  I am using a 4 flute 1/2" bit, with a OAL of 9". 

2

General Mach Discussion / Re: problems with larger bit and machine stuttering

« on: October 10, 2010, 10:14:20 AM »

ok, I will have to check around, I live in New Jersey in the US.  I am sure that there is someone around that can do it.  Thanks!

3

General Mach Discussion / Re: problems with larger bit and machine stuttering

« on: October 10, 2010, 10:10:40 AM »

Ok, i will try that.  Where would I take the bit to get sharpened, since these bits are more precision than drill bits.

4

General Mach Discussion / problems with larger bit and machine stuttering

« on: October 10, 2010, 09:59:19 AM »

Hi, I am using this machine to create sculptures of mine.  Though every time I use a larger bit (lately only) the machine keeps stuttering.  What I mean by this is that it will be running, then all of a sudden make a *jammed sound* then continue and it will mess up the piece i am working on.  So my solution has ben to stop it, re-zero home, then input my "zero's" and start again.  The problem is that it is doing it more often now.  I don't think that the bit would cause this to happen since we have run this 1/2 inch bit on it many of times already.  I have cleaned out both the computer and the box for the machine by using compressed air, and get all the dust out.  Any other suggestions?  I need to get this thing working properly, because I need it for my thesis work!!

Adam