Messages

1

Modbus / Re: Mach3, Arduino, Modbus and MPG

« on: February 25, 2013, 01:20:14 PM »

Hi guys
I think the problem with arduino mpg is the same as when connected to some BOB, the debouncing, Mach3 has to adjust it but does not properly with the mpg, this requires putting buffer and / or convert step and direction signals (see attached)

2

Modbus / Re: Mach3, Arduino, Modbus and MPG

« on: February 08, 2013, 05:33:24 PM »

Zafar:
Were you able to properly configure the MPG?.
As you connected? .

3

Modbus / Re: Simple tutorial on analog inputs with Arduino

« on: January 19, 2013, 08:13:00 AM »

Good job works perfect
I am new to this and would like to put buttons and LED on the arduino but I can not run or signals the brain
can you help

Thanks

4

Modbus / Help Arduino Modbus RTU

« on: January 19, 2013, 08:03:56 AM »

Hi guys
I'm trying to use my arduino mega as Modbus but I can not activate inputs or outputs to put buttons and LEDs.
The feed and speed potentiometers for misalignment with the brain
http://www.machsupport.com/forum/index.php/topic,22980.0.html

For example like putting a running Cycle Start button

And LED lights to run Cycle Start

I hope you can help me

thanks

5

VB and the development of wizards / Re: turn on an LED when activated function

« on: March 07, 2012, 11:12:40 AM »

I have a doubt if one could make a macro to activate a LED when you run the gcode execution mode.
for example:
you turn on an LED when activated  (mirror x)
and off when no longer in use.
Would it be possible?
Someone can help me
Thank you.

6

VB and the development of wizards / turn on an LED when activated function

« on: March 05, 2012, 03:18:07 PM »

I have a doubt if one could make a macro to activate a LED when you run the gcode execution mode.
for example:
you turn on an LED when activated function M21 (mirror x)
and off when no longer in use.
Would it be possible?
Someone can help me
Thank you.