1
General Mach Discussion / N00b 2.5D Question
« on: September 05, 2010, 08:53:24 PM »
Hi All -
I'm setting up a 2.5D system (manual Z-axis) and was trying to find a way to get Mach3 to pause and wait for input when it gets a command to
move in Z. I'm sure there's got to be a configuration button somewhere obvious, but I'm totally missing it. Can y'all give me a shove in the
right direction?
Thanks
Jamie
I'm setting up a 2.5D system (manual Z-axis) and was trying to find a way to get Mach3 to pause and wait for input when it gets a command to
move in Z. I'm sure there's got to be a configuration button somewhere obvious, but I'm totally missing it. Can y'all give me a shove in the
right direction?
Thanks
Jamie