Messages

1

General Mach Discussion / Re: not circle that is a polygon

« on: August 26, 2010, 07:43:44 AM »

no. i have my own license. i purchased myself from scott nichols.
do you think my license is fake. this is a very big problem.

2

General Mach Discussion / Re: not circle that is a polygon

« on: August 26, 2010, 05:15:30 AM »

I am using 3.042.040 version of mach with license.
i dont think so my problem about license.
i count 40 segmented lines at one circle.

3

General Mach Discussion / Re: not circle that is a polygon

« on: August 25, 2010, 07:38:07 AM »

i know perfect circle imposible for x.y.z machines.  But my surface is very bad. i am using servo system. My mechanical equipment is very good.
i think my mach3 setting is wrong or circular interpolation is not enough. i send my setting file.

4

General Mach Discussion / not circle that is a polygon

« on: August 25, 2010, 06:12:32 AM »

i want to make circle cutting but i failed. try all of CV settings.

g code example:
F400
G00 Z10
G00 X7.5 Y0
G00 Z1
G01 Z-0.5 F50
G02 X7.5 Y0 I-7.5 J0 F400
G01 Z-1 F50
G02 X7.5 Y0 I-7.5 J0 F400

i zoom toolpath screen. this is not a perfect circle. it is segmented. When i was cutting a circle, surface is choppy.