Messages

1

Share Your GCode / Post for Mach3

« on: November 08, 2010, 10:03:53 AM »

I', looking for the post to run my Master Cam MR2 (10.2.2.31) also says Ver. 0.17.1.167. I would like to do my drawning in my autocad and run through my Master Cam which I use in my shop. Any help would be good.

2

General Mach Discussion / Would like to hook up a touch pad

« on: November 07, 2010, 07:44:03 AM »

I'm from Parkersburg,WV. I have been tiring most of yesterday to get a tool touch pad to work on my Mach 3 cnc. I built a cnc router about a year ago, and now have hooked up a MP2CP pendant from Texas micro circuit and it all works fine. I would like to use the touch pad that I see other mach3 user using. I have hooked up a wire to pin 15 and one to ground and would like to use the auto zero button already on on the screen, will this not work. And do I get the program for this, really not sure what I'm doing any help would be good.