Hello Guest it is November 27, 2020, 09:35:37 PM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - jamied

Pages: 1 2 3 »
1
CS-Lab / Re: outputs 4 and 5 on CSMIO
« on: October 15, 2013, 04:10:08 PM »
fixed ! was setting the output pins wrong !! its getting late

2
CS-Lab / outputs 4 and 5 on CSMIO
« on: October 15, 2013, 03:46:50 PM »
just setting up mu ports and pins settings for my VFD  have configured the spindle CW to output 4 and CCW to output 5 and set the pins in the output signals to (output 4 port 10 pin 12) and (output 5 to port 10 pin 13 ) both enabled , but its not switching on the relay on the CSMIO ?? if i set the CW or CCW spindle settings to either 1,2,or 3 outputs they all energies but not 4 or 5 ?? what am i doing wrong ?

3
General Mach Discussion / Re: servo drives and ecoders
« on: October 08, 2013, 10:09:29 AM »
I dont have the software as yet but its not expensive ,   have attached the manual for the software ( may not be the most up to date version) , the motors are Yasakawa  USAFED-09FB1S , thanks again Hood

4
General Mach Discussion / Re: servo drives and ecoders
« on: October 08, 2013, 09:48:03 AM »
Hi Hood , just want to pick your brains again:) i have contacted Omron (very helpful guy) and software is available to set up there drives, so it may be possible to set the drives I have to the motors I have ?? whats your opinion (hardest thing may be getting hold of the datasheets for the Yasakawa motors to get the required information ?)

5
General Mach Discussion / Re: servo drives and ecoders
« on: October 06, 2013, 04:55:47 PM »
Ok Hood appreciate your advice on this . Nothing's ever straight forward :) will see if I can get some information on them

6
General Mach Discussion / Re: servo drives and ecoders
« on: October 06, 2013, 04:38:08 PM »
Yea true what about the FD432-LA series that zapp automation advertise 

7
General Mach Discussion / Re: servo drives and ecoders
« on: October 06, 2013, 04:31:52 PM »
Yes the originals are dead , so I need motors to match these drives or motor and drives that are paired ? Shame these motors I have are fine

8
General Mach Discussion / Re: servo drives and ecoders
« on: October 06, 2013, 04:12:12 PM »
Yes true so my best options would either be to find new servo drives that will work the motors I have or change the motors for ones that will either work with these drives or different motors and drives  all together ?

9
General Mach Discussion / Re: servo drives and ecoders
« on: October 06, 2013, 03:17:36 PM »
Oh so it may not be so simple !

10
General Mach Discussion / Re: servo drives and ecoders
« on: October 06, 2013, 03:16:28 PM »
Yes the motors are 200v  3phase  750w motors , I'm thinking of using the feedback encoders off the ball screws as they have A+ ,A-, B+B-,,GZ+GZ- and if you look at CN1 there's a  pair of Zphase connections , am I wrong I'm thinking that's my GZ phase ?


Pages: 1 2 3 »