Messages

1

Show"N"Tell ( Your Machines) / Re: The Laser Project.

« on: August 13, 2010, 06:27:05 AM »

> “What causes the vertical striations to be made ?”.

You did . If you tell the machine to cut lots of straight lines that is is exactly what it does.

Richard
UK

2

Galil / Re: Galil Status

« on: August 05, 2010, 01:24:28 PM »

Of course I hadn't looked in the one most obvious place... My embarrassment is doubled by apparently being unable to edit my original post after a certain amount of time

Richard

3

Galil / Re: Galil Status

« on: August 05, 2010, 01:06:24 PM »

It's probably very obvious if you've been here a while, but where can I download it please?. I have searched here but there are just too many hits.

Richard