1
Mach3 under Vista / Re: Mach3 support for windows 7?
« on: February 28, 2013, 11:43:16 AM »
I was using XP Hone and wanted to update to sp1 and then sp2 and then sp3 I was unable to do the upgrades so I went to win 7. The Mach3 driver test worked and the readings looked good. The computer starts OK and will run for hours with no problems. Sometimes when I start Mach3 it locks up (hard reboot required) Sometimes I can load a tap file and run the file the table does what it is suppose to do. The lockups have not happened while running a tap file yet!! I am thinking of going back to XP
Keith
Keith