Hello Guest it is March 28, 2024, 09:06:33 PM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - ref1ection

Pages: 1
1
Mach4 General Discussion / Re: Unable to connect to ShuttlePro
« on: January 27, 2018, 02:06:50 PM »
I tried that again and still no response to buttons in setup dialogue box.

Ray

2
Mach4 General Discussion / Unable to connect to ShuttlePro
« on: January 27, 2018, 06:58:09 AM »
I have the shuttlepro working in other programs but I’m unable to connect to it in Mach4. After activating the plugin in Mach4 I get no response when the dialogue box pops up asking to press a key. I’ve searched but didn’t find an answer to this and assume I’ve missed a detail somewhere in the settings.

Thanks
Ray


3
Mach4 General Discussion / Re: Math in DRO
« on: January 23, 2018, 09:05:42 PM »
Thank you joeaverage. That's exactly what I was looking for.

4
Mach4 General Discussion / Math in DRO
« on: January 23, 2018, 05:40:59 PM »
In Mach3 it was possible to find the center of a part by finding the left edge, set X0.0, find right edge, click in X DRO, type /2, hit enter and the distance would be halved. Is there a way to do this in Mach 4?
Thanks Ray

5
Have you had any further progress getting 0-10v on the analog output? I'm trying to do the same with a C23 board and having the same issues.

6
General Mach Discussion / Re: Sudden unexpected movements
« on: August 05, 2010, 11:17:40 AM »
No, nothing shows on the dro's

7
General Mach Discussion / Sudden unexpected movements
« on: August 05, 2010, 11:15:20 AM »
I was just wondering if anybody has ever had there machine suddenly start moving on it's own toward the travel limits and keep trying to continue even after homing? Any suggestions would be welcome to cure this.

Ray

Pages: 1