1
General Mach Discussion / CamBam export g code into Mach3
« on: June 02, 2012, 09:43:32 PM »
I have searched a lot, here is my results. I am trying to machine a 3D object, drawn in Viacad. STL import into CamBam, toolpathed and g code are done. This is where I get lost. It seems Lazycam only imports/exports 2 and 2.5 dxf drawing into Mach3. Lazycam is the only way to get a drawing into Mach3. However, Can I export/import my 3d drawings g-code from CamBam into Mach3? Am I limited in Mach3 usage in doing so? I am going through everything (tutorials) and the manual again, as I am still new, but am asking this as a course of direction so as not to waste time and energy. Thank you, Robert