Messages

1

General Mach Discussion / Re: g code will not load completely on tool screen

« on: August 09, 2010, 04:53:49 PM »

Hood,

  Thanks for the help.  That was the problem.  For some reason the license file got corrupted I guess.  I just copied it again into the Mach 3 directory.

Morgan

2

General Mach Discussion / Re: g code will not load completely on tool screen

« on: August 07, 2010, 04:29:13 PM »

Greolt,

  Thanks for the reply.  I did buy a license when I bought my machine from K2cnc.  They preloaded on my new computer at their factory.  How can I tell if it is done correctly?

Thanks,

Morgan

3

General Mach Discussion / g code will not load completely on tool screen

« on: August 07, 2010, 01:47:29 AM »

I have designed three gears in Cambam and tested them in cutviewer.  Everything runs fine.  When I load it into Mach 3 theg code appears to load but only about 2/3 of one of the gears loads and appears on the screen.  I am lost.  Could it be a memory problem on the computer?

Help please!

Morgan