Hello Guest it is March 29, 2024, 08:23:01 AM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - mrpenguin

Pages: 1
1
General Mach Discussion / Re: New User to Mach 3 ....... Help!!
« on: July 22, 2010, 02:52:48 PM »
ger21, when i reference the z-axis to the top of the material, zero it out, and hit regen toolpath; i then run the program and the z-axis jumps up to a height and then starts drilling. the problem is that when it does that the bit isn't anywhere close to the top of the material. I've been fighting with this off and on for the past two days. any ideas of why this is happening and what i can do to fix it?

Pages: 1