Hello Guest it is March 29, 2024, 07:29:35 AM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - AAndreeww

Pages: 1
1
dspMC/IP Motion Controller / Re: dspmc with mach3 - output problem
« on: August 13, 2010, 04:30:45 PM »
Hi!

I solved my problem. In tab "Port and Pins" >> "Spindle Setup" I set the port for my connection to dsp module.
Then I create a brain which contain open contact "Mist On" and other important for my machine.

2
dspMC/IP Motion Controller / Re: dspmc with mach3 - output problem
« on: July 22, 2010, 02:00:13 PM »
I only need to know how the built in m7,m8,m9(coolant) macros are work and how i can use it to my machine.

3
dspMC/IP Motion Controller / Re: dspmc with mach3 - output problem
« on: July 22, 2010, 08:41:26 AM »
It works now.
thanks a lot.
I have another question. I'd like to use m7,m8,m9 function. I wrote some VB-code in files m7.m1s......
Files are in good destination. When i run spript from script editor it works good. But when i write m7,m8 or m9 in mdi input nothing hapens.
How can i use my function or edit actually built in??
 

4
dspMC/IP Motion Controller / dspmc with mach3 - output problem
« on: July 20, 2010, 05:03:11 AM »
Hi!

I have problem with otput0(on the board pin0). When starting axisworks i can control 16 outputs without any problem. When I run mach3 with dspmc plugin, push reset button the output0 goes high. It's strange because i dont have any output assigned in "Port and Pins". It looks like mach3 control this output but i cant find how.
Can you help?

Pages: 1