Hello Guest it is November 30, 2021, 08:29:01 PM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - mpryne

Pages: 1
1
General Mach Discussion / Re: wells index cnc 700conversion to mach3
« on: September 07, 2010, 03:16:52 PM »
thie controller is a bandit

2
General Mach Discussion / wells index cnc 700conversion to mach3
« on: August 30, 2010, 10:41:54 AM »
Anyone out there already converted cnc wells index to mach control?

3
General Mach Discussion / Re: new to Mach/about to convertexisting cnc
« on: August 30, 2010, 10:35:32 AM »
Also i have a second question. i am aware that mach is rather finicky about the computers it will run on. Are the older gateway pc's generally acceptable and compatible?

4
Hey,
Mike Pryne
Blanchester ohio
small business owner fabrication/ welding
about to install mach3 on a existing cnc and if i like it i will do three more..


5
General Mach Discussion / new to Mach/about to convertexisting cnc
« on: August 30, 2010, 09:23:17 AM »
Hey guys.
I have been following mach for about a year and i am ready to convert one of my wells index cnc 700's to pc control.
Any suggestions on the best version of windows to install mach with? This will be a dedicated computer for machine control only.

Mike

Pages: 1