Messages

1

FAQs / Re: Setting Mach 3 Port to PCI parallel port address

« on: June 15, 2010, 04:05:09 PM »

Hey, came across the same problem yesterday; bought a PCI parallel port and installed it, but didn't have any activity when I checked the IO viewer.  Had to go to my BIOS and enable the parallel port as it was defaulted to "disabled"...  This doesn't make a heck of a lot of sense, seeing as this isn't an onboard parallel port, but it worked.  Now I have output to my PCI parallel from KCam.  Shazaam!