Hello Guest it is March 29, 2024, 12:00:20 PM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - tulsaturbo

Pages: 1
1
Mach Screens / Re: Mach3 input dialog box for Z-axis offset
« on: January 30, 2011, 05:52:02 PM »
I also have a question emailed to Hypertherm support about using their Ohmic sensor cap as a Z-axis home switch.  This may solve all my problems with flexing material...

Can you tell me how you are wiring the ohmic sensor cap as a home switch? How is it wired to complete the circuit?

2
May I ask what version of Windows you are running. I run XP. I tried copying the XML file, but when I run the machine, the measurements are way off so I have to redo the step on each axis which leads to different numbers to get the measurements correct.

3
Between my 3 computers running Mach3, each one has different (steps per inch) settings under motor tuning for the same cnc machine.

I have always wondered about that since backing up my mach settings for the motor tuning won't apply on another pc.

Has anyone run into this scenario?

Pages: 1