Messages

1

General Mach Discussion / Re: Error triggered Art code: 1

« on: June 30, 2010, 11:32:44 AM »

I'm testing a new plugin, it works on the developement machine but on a plain xp pc it triggers " Error triggered Art code: 1" at startup.
Any hint about what is triggering this message?
If I remove the experimental plugin there is no error and Mach3 works fine so I'm fairly sure Mach3 is properly installed on both the machines.

2

PoKeys / Re: PoKeys Version 10.0 plugin released!!!

« on: May 13, 2010, 02:31:07 AM »

You are completely correct, the idea is to use them as actuator in accessories. Nothing involving interpolation and probably a spring in between to avoid the risk of killing the plastic gears.

PD

3

PoKeys / Re: PoKeys Version 10.0 plugin released!!!

« on: May 12, 2010, 08:19:42 AM »

Forgot to tell I'll be happy to alfa test the plugin

PD

4

PoKeys / Re: PoKeys Version 10.0 plugin released!!!

« on: May 12, 2010, 07:24:47 AM »

Ok, 13 values. There are 6 enable flags, 6 values and one period. Any block of the user DRO is ok as far as it is known.
I wish to be able to write an exact value and an exact period. Maybe is ok to leave the the enable flag to the configuration utility. Given that the period is not going to change often it may as well belong to the configuration.
I drop spindle control and display in favor of the availability of 6 'servo' controls.

PD

5

PoKeys / Re: PoKeys Version 10.0 plugin released!!!

« on: May 12, 2010, 03:25:07 AM »

Talking about another evolution, it would be possible to have access to the 12 values needed to drive the six pwm?
It would make the pwm available as general use analog out?
It may be fairly straightforward, isn't it?

Best Regards
PD