Messages

1

General Mach Discussion / Re: Problem MACH3 X-axis DRO scale dispay

« on: May 26, 2010, 06:57:47 PM »

There are to Plugins enabled:
- Flash-Flash Sceen-SWF PlugIn
- Video PlugIn

Brain Control shows ModIOMPG.Brn is loaded but not enabled.

Peter

2

General Mach Discussion / Re: Problem MACH3 X-axis DRO scale dispay

« on: May 26, 2010, 05:51:32 PM »

Hi Hood,

attached you will find my XML "Mach3Mill_peterstg.xml". I hope it helps to find the problem.

Peter

3

General Mach Discussion / Re: Problem MACH3 X-axis DRO scale dispay

« on: May 26, 2010, 12:35:51 PM »

Hi all,

thanks for quick response. I meant the scale value for the x-axis changed by itself while mach3 is milling. This hapens with every Gcode-file I tested. After short time the value changes to -1.000.

Peter

4

General Mach Discussion / Problem MACH3 X-axis DRO scale dispay

« on: May 25, 2010, 08:54:07 PM »

I'm new in this forum and new with Mach3.
My question concerns the 'Program run display' and there the 'Scale display on x-axis DRO display'. This scale display changes the value from +1.000 to -1.000 while machining and the cutter moves in the opposite direction. As Gcode I used the Roadrunner example and others.
What I'm doing wrong?  Is anything missconfigured?

Peter