Hello Guest it is June 04, 2020, 03:52:50 PM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - Jeff@Janed

Pages: 1
1
General Mach Discussion / Program home
« on: May 06, 2010, 09:47:56 AM »
Hey,
I hope someone will know this. Is there a program home on the Mach 3? After running the program I need to move the head out of the way so that I can put up a new part. If I hit refer all home it goes home but when I hit run it doesn’t go back to the part. Is there a way to do this without manually going back to my program starting point? On my water jet I just hit goto “program 0”

Thanks Jeff

2
Hey I'm Jeff located in NY.
I have been programming / running a water jet machine using Sigma Nest for the past 10 years. Just getting started with Mach3 for milling. I'm using Bob CAD for the programming.

Pages: 1